Log In

Forums › Erbium Lasers › General Erbium Discussion › Polishing Erbium Tips

  • This topic is empty.
Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • February 25, 2003 at 12:15 am #6505 Reply

    Benchwmer
    Spectator

    My Photos1 006.jpg
    How do you polish your ERBIUM tips?
    I ordered a Brassler polishing diamond wheel kit. Where do I go from there?
    Thanks. Jeff

    February 25, 2003 at 4:19 am #6506 Reply

    Glenn van As
    Spectator

    Hi Jeff. I just take a cup of one of these flat polishing discs and buff the end very slowly with a slowspeed under high mag to try and take the shards off.

    My guess is that you get a 50% improvement over the old tip, but I will ask that you check with Opus dent if this is ok as I know it is fine with the Conbio but might not be fine with the Opus.

    Glenn

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
Reply To: Polishing Erbium Tips
Your information: