Log In

Forums › Erbium Lasers › General Erbium Discussion › Waterlase maintenance

  • This topic is empty.
Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • November 20, 2005 at 1:52 pm #7671

    whitertth
    Spectator

    have u been properly trained. Some units need maintenance and a contract is important but you must be trained properly. Try to attend either our training course in NY or Barr/ Colona or any other training courses and then see how your laser cuts. where r u located?

    November 20, 2005 at 8:09 pm #7672

    Glenn van As
    Spectator

    Several factors come to mind when discussing poor cutting ability

    1. As Ron said……you must have clinical training
    2. You must have higher than average magnification. A minimum of 4.5X has been suggested. 6.0X is better. A scope is best
    3. You should have your machine inspected to see if it is working properly. Is the handpiece and mirrors ok. Is the fiber ok.

    There are alot of factors including expectations (its not ever going to be as fast as a handpiece) that affect performance, and I would suggest that if you want to make a concerted effort to use the laser more that you include the above mentioned variables when attempting to conquer the learning curve regardless of laser brand.

    Sincerely,

    Glenn

    November 21, 2005 at 1:08 am #7670

    Anonymous
    Guest

    <a href="http://www.rwebstudio.com/cgi-bin/ikonboard//topic.cgi?forum=36&topic=17&#8243; target=”_self”>Moved here

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • The topic ‘Waterlase maintenance’ is closed to new replies.