Forums Erbium Lasers General Erbium Discussion Delight Laser, Error 24

  • This topic has 3 replies, 3 voices, and was last updated 2 years, 1 month ago by  OSCAR J ROMERO R.
Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #2983 Reply

    Albodmd
    Spectator

    When I received my new Delight laser, I was getting an Error 24 on the display. Tech checked it out and then it worked fine. This week I’ll sometimes get the Error 24, turn it off and on, change some settings, and then things will work again. The rep and I think something is loose in the laser. Tech will be coming out again to check it out. Anyone else ever get Error 24? Conbio has been really great in trying to get this problem resolved and have promised me a new laser if it isn’t fixed soon.
    Regards,
    Al B

    #7836 Reply

    Glenn van As
    Spectator

    Email me privately at glennvanas@shaw.ca

    Thanks Albert.

    Tell me when it happens and also what settings. Do you also get an error 98 as well?

    Glenn

    #46298 Reply

    OSCAR J ROMERO R
    Guest

    Hi, I have the same type of error 24, and in calibration error 98, any suggestions?

    Oscar Julian

    #46300 Reply

    OSCAR J ROMERO R
    Guest

    Gracias por du interes, el error 98 aparece en calibraciĆ³n , los errores 22 y 24 en las configuraciones Enamel, dentina, caries s1 y s2.

Viewing 4 posts - 1 through 4 (of 4 total)
Reply To: Delight Laser, Error 24
Your information: